Pant Cutting Formula Pdf 28
Losing this amount of weight weekly is not healthy at all. In fact, cutting weight like this should be minimized whenever possible. That said, losing 5-10 lbs. of water weight if you are 180-lb.+ male is generally quite easy, even by simply cutting water intake to 1/3 and purified, while consuming a few more cups of coffee.
To increase thigh width: Pin or tape tissue paper under front and back pattern pieces along both inseams and outer seams. Mark 1/4 of the total addition along the side seams and inseams outside the cutting lines. Draw new cutting line through markings along side seam from hip, tapering into original cutting line near hem. On inseam, start new cutting line at crotch point and redraw cutting line, tapering back to original cutting line near hem (Figure 16).
After the pattern has been cut, take time to press a crease in the front of each pant leg (if required in the instructions). Use the pattern markings to determine where the creases should be. Stop the crease at the crotch. To ensure a firm crease, use a damp cloth and steam. Remember, it is difficult to remove creases set in synthetic fabric, so be sure to set them correctly.
When using ORS, try to get the victim to ingest a quart per hour until the frequency of urination begins to increase and the urine color turns light or clear. To begin, start with small (e.g. 5 mL or one teaspoon) amounts every 1 to 2 minutes, to avoid collection of a large amount of fluid in the stomach that might cause vomiting. A child should be given 11/2 oz (44 mL) of ORS per pound (0.
Once you do your pattern, cut along the cutting line. For the mock-up, I used only a pattern piece, but if you have the correct pants pattern, a small amount of paper that is not part of the pattern will give the best results. To reduce the bulk and make pattern matching easier, you can cut the paper along the edges defining the pattern, too. Half of the pattern to make adjustments.
To increase hip width: On the pattern piece, make a pair of parallel lines on both sides of inseam. Double weight of fabric over included piece and, using a ruler, mark the desired amount, using the parallel lines on the inseam to locate the seam. Cut a piece of paper along the pencil lines.